Switch# show startup-config Why does the switch respond via startup-config is not present? Karena belum konfigurasi belum disimpan. Part 2: Create a Basic Switch Configuration Step 1: Assign a name to a switch. To connumber parameters on a switch, you may be required to move between miscellaneous configuration settings. I review in book that it has to be tbelow initially once you get new rexternal unless someone rerelocated configuration file from NVRAM. Sexactly how more When I go to allow mode and type sh run I watch the config file in rexternal RAM exist but as soon as I form sh start I get startup-config is not existing definition NVRAM do not have actually it.

You are watching: Why does the router respond with the startup-config is not present message?

.This lab is about 6.4.1.3 Packet Tracer – Configure Initial Rexternal Settings. In this tutorial we will comment on about 6.4.1.3 Packet Tracer answers, in last tutorial we discuss about Introduction to.6.4.1.3 Packet Tracer Answer6.4.1.3 Packet Tracer – Configure Initial Rexternal SettingsHere we have actually topology of 6.4.1.3 Packet Tracer – Configure Initial Router Settings. Equipment’s which we compelled are as follows. 1 Router.

*

Run Command For Startup Config

1 PC6.4.1.3 Packet Tracer Lab ObjectiveWe have actually few missions of this lab which we have to execute. Verify the Default Router ConfigurationStep 1: Establish a Console cable Connection to R1. Choose a Console cable from the easily accessible connections. Click PC-A and also pick RS 232.

See more: There Are Two Closing Entries. The First One Is To Close _____; The Second One Is To Close _____.

Click R1 and select Console. Click PC-A Desktop tab Terminal. Click OK and also push ENTER. You are now able to connumber R1.Step 2: Enter privileged mode and also research the present configuration.Get in right into the Rexternal 1 Privileged mode by the adhering to regulates and also them examine the existing configurations of the router.Enable the command use to Go into right into the privileged EXEC mode. Save the Running Configuration Documents Step 1: Save the configuration file to NVRAM.You have configure the initial settings for R1. Now earlier up the running configuration file to NVRAM to ensure that the alters made are not lost if the system is rebooted or loses power.What command did you enter to save the configuration to NVRAM?

Startup-config Is Not Present out Why Does This Post Appear

Copy running-config startup-configWhat is the shortest, unambiguous variation of this command? Copy r sWhich command also display screens the contents of the NVRAM? Show startup-configuration or present startVerify that every one of the parameters configured are videotaped. If not, analyze the output and identify which regulates were not done or were gotten in erroneously. You have the right to additionally click Check Results in the instruction home window.